Spectrum-controls 140 ACI 052 00sc Manuel d'utilisateur télécharger pdf (Page 37)

4.3 Module status information (Register 3x+8)

The information provided in this register is generic information about this

module. Bits 1-8 and 10 provide error status information. Bits 11-16 indicate

what information is present in the current inputs registers.

1 2 3 4 5 6 7 8 9 10 111213141516

Group Select

Data Input Mode Selected

Configuration Error

Reserve

Out of range Channel 1-4

Out of range Channel 5-8

Out of range Channel 9-12

Out of range Channel 13-16

Out of range Channel 17-20

Out of range Channel 21-24

Out of range Channel 25-28

Out of range Channel 29-32

3x+8 Out of Range Error: Bits 1-8

These eight bits indicate that an over or under range condition or an alarm

condition exists on at least one channel within the group. Bits 1-8 correspond

to eight groups of four channels each. When an Out of Range Flag is set,

the Channel Status mode (see Section 4.3) can be enabled to report which

channel is out of range.

☞ Note: An over range error indicates that a channel input is a value greater than or equal to the

maximum for the range selected for that channel group. An under range error indicates

that a channel input is a value less than or equal to the minimum for the selected range.

3x+8 Reserved: Bit 9

Bit 9 should always respond with a 0.

Installation Instructions

32-Channel Analog Input Module

Quantum Series 140 ACI 052 00sc

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 61 62

Pas de commentaire

Spectrum-controls 140 ACI 052 00sc Manuel d'utilisateur Page 37