Spectrum-controls 1762sc-IF8U Manuel d'utilisateur télécharger pdf (Page 16)

2-6 MicroLogix™ 1200 IO Universal Input Module

User'sManualPub.0300243‐02Rev.B

Note: For environments with extreme vibration and shock concerns, use

the panel mounting method described below, instead of DIN rail mounting.

2.4.3 Panel Mounting

Use the dimensional template shown below to mount the module. The preferred

mounting method is to use two M4 or #8 Pan Head screws per module. M3.5 or #6 Pan

Head screws may also be used, but a washer may be needed to ensure a good ground

contact. Mounting screws are required on every module.

Figure 2-3

Section 2.5

System

Assembly

The expansion I/O module is attached to the controller or another I/O module by means

of a ribbon cable after mounting as shown below.

Figure 2-4

Note: Use the pull loop on the connector to disconnect modules. Do not

pull on the ribbon cable.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

Pas de commentaire

Spectrum-controls 1762sc-IF8U Manuel d'utilisateur Page 16