Spectrum-controls 1762sc-IF8U Manuel d'utilisateur télécharger pdf (Page 15)

Chapter 2: Installation and Wiring 2-5

User'sManualPub.0300243‐02Rev.B

Figure 2-1

Note: 1762 expansion I/O may be mounted horizontally only.

Attention

During panel or DIN rail mounting of all devices, be sure that all debris

(metal chips, wire strands, etc.) is kept from falling into the module.

Debris that falls into the module could cause damage when power is

applied to the module.

2.4.2 DIN Rail Mounting

The module can be mounted using the following DIN rails: 35 x 7.5 mm (EN 50 022 - 35

x 7.5) or 35 x 15 mm (EN 50 022 - 35 x 15).

Before mounting the module on a DIN rail, close the DIN rail latch. Press the DIN rail

mounting area of the module against the DIN rail. The latch will momentarily open and

lock into place.

Use DIN rail end anchors (Allen-Bradley part number 1492-EA35 or 1492-EAH35) for

environments with vibration or shock concerns.

Figure 2-2

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Pas de commentaire

Spectrum-controls 1762sc-IF8U Manuel d'utilisateur Page 15