Spectrum-controls 1769sc-IR6I Manuel d'utilisateur télécharger pdf (Page 54)

B-2 Compact™ IO Isolated RTD/Resistance Module

User’s Manual Pub. 0300241-01 Rev. A

For example, to obtain the general status of channel 2 of the module located in slot e, use

address I:e.6/2.

Note: The end-cap does not use a slot address.

B.1.1 1769sc-IR6I Configuration File

The configuration file contains information you use to define the way a specific channel

functions. The configuration file is explained in more detail in Configuring Channels on

page 4-2.

The configuration file is modified using the programming software configuration screen.

For an example of module configuration using RSLogix 500, see Configuring the

1769sc-IR6I in a MicroLogix 1500 System on page B-2.

Table C-1 (Software Configuration Channel Defaults)

Parameter Default Setting

Filter Frequency 10 Hz

Cyclic Lead Compensation Yes

Open-Circuit Response Upscale

Temperature Units C˚

Input Type 100  Pt 385

Data Format Raw/Proportional

Disable/Enable Channel Enable

Section B.2

Configuring the

1769sc-IR6I in a

MicroLogix 1500

System

This example takes you through configuring your 1769sc-IR6I Isolated RTD/Resistance

input module with RSLogix 500 programming software, assumes your module is

installed as expansion I/O in a MicroLogix 1500 system, and that RSLinx™ is properly

configured and a communications link has been established between the MicroLogix

processor and RSLogix 500.

May be overridden by the software.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 73 74

Pas de commentaire

Spectrum-controls 1769sc-IR6I Manuel d'utilisateur Page 54