Spectrum-controls 140 MPM 204 00sc Manuel d'utilisateur télécharger pdf (Page 57)

Meter Proving Module

CorrCorr

Corr

ective ective

ective

ActionAction

Action

If necessary, install a pull-down resistor between the channel input and channel common or a pull-up resistor

to a positive voltage source.

Module Not Recognized by Rack (ModSoft)Module Not Recognized by Rack (ModSoft)

Module Not Recognized by Rack (ModSoft)

Possible CausesPossible Causes

Possible Causes

• Module not correctly installed.

• Module runtime files not correctly installed.

CorrCorr

Corr

ective ective

ective

ActionAction

Action

1.1.

1. Reinstall the module in the rack. See chapter 2, “Installation and Wiring.”

2.2.

2. Check the I/O map screen in ModSoft to see if the problem still exists.

3.3.

3. If the module name is still marked with an asterisk (indicating a health status problem), select the

module name using the Shift+? key.

4.4.

4. If the module is not listed at all, reinstall the ModSoft runtime files. See software installation

instructions in chapter 3, “Module Configuration.”

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 65 66

Pas de commentaire

Spectrum-controls 140 MPM 204 00sc Manuel d'utilisateur Page 57